Skip to content
Pool Chemical Log

How Much Baking Soda for a 30,000-Gallon Pool?

Updated

On this page

Raising total alkalinity by 10 ppm in a 30,000-gallon pool takes 67.2 oz (4.20 lb) of baking soda (sodium bicarbonate). A 30 ppm rise takes 201.7 oz (12.61 lb). Indiana's health department advises "Do not attempt to raise it more than about 50 ppm at one time", which for this pool is 336.2 oz (21.01 lb).

Baking soda doses for a 30,000-gallon pool

Raise total alkalinity byBaking soda
10 ppm67.2 oz (4.20 lb)
20 ppm134.5 oz (8.41 lb)
30 ppm201.7 oz (12.61 lb)
40 ppm269.0 oz (16.81 lb)
50 ppm336.2 oz (21.01 lb)

The amounts are for 100% sodium bicarbonate, the strength on HASA's Alkalinity Up safety data sheet, and plain grocery baking soda is the same chemical. Published rules of thumb sit close to it: PHTA's alkalinity fact sheet says about 1.5 lb per 10 ppm in 10,000 gallons, which is 4.50 lb here, Toledo-Lucas County's health department says "approx 1.5 lbs", and the arithmetic from the molar masses gives 22.4 oz (1.40 lb) for 10,000 gallons.

How far to raise it

The MAHC 2024, a public-pool code, sets 60 to 180 ppm. PHTA narrows the ideal by sanitizer: 80 to 100 ppm for calcium hypochlorite, sodium hypochlorite or a salt chlorine generator, and 100 to 120 ppm for dichlor and trichlor. Stabilizer shows up in the alkalinity test too, so a pool with a lot of cyanuric acid reads higher than it really is; the pH and alkalinity calculator corrects for it before sizing a dose.

Worked example

A 30,000-gallon pool reads 75 ppm after an acid wash of the salt cell went back in without a rinse. The owner aims for 95 ppm. That is a 20 ppm rise, which in 30,000 gallons takes 134.5 oz (8.41 lb), small enough to go in at once. The next salt cell clean is rinsed off before the cell goes back, as how to clean a salt cell describes.

Adding it

Indiana's handling list says "Dissolve powders or crystals in water before adding to the pool." and "Add large amounts gradually in thirds over a 2-hour period." It also warns that "Sodium Bicarbonate will also raise the pH of the pool water slightly." and that "Sodium Carbonate (Soda Ash) is NOT the same as Sodium Bicarbonate (Baking Soda)." Soda ash raises pH much more, so check the bag. One more caution from the same sheet: "If the TA is at or below 50 ppm, be sure to test for metals in solution before adding Soda Ash or Baking Soda to the pool."

Is your pool really 30,000 gallons?

Every amount on this page scales with the water, so a pool 20% bigger than you think needs 20% more of everything. Here are two pools that hold close to 30,000 gallons, worked with the same formulas as the pool volume calculator:

PoolGallons
A round pool 33 ft across, 4.5 ft average depth28,791
A rectangle 20 × 40 ft, 5 ft average depth29,922

If yours is another shape, or you only know its size roughly, measure it and run the calculator first. The raise alkalinity guide covers the order to work in when pH is low as well.

The same doses in other pool sizes

Pool size+10 ppm+30 ppm+50 ppm
5,000 gal11.2 oz33.6 oz (2.10 lb)56.0 oz (3.50 lb)
10,000 gal22.4 oz (1.40 lb)67.2 oz (4.20 lb)112.1 oz (7.00 lb)
15,000 gal33.6 oz (2.10 lb)100.9 oz (6.30 lb)168.1 oz (10.51 lb)
20,000 gal44.8 oz (2.80 lb)134.5 oz (8.41 lb)224.1 oz (14.01 lb)
25,000 gal56.0 oz (3.50 lb)168.1 oz (10.51 lb)280.2 oz (17.51 lb)
30,000 gal (this page)67.2 oz (4.20 lb)201.7 oz (12.61 lb)336.2 oz (21.01 lb)

Alkalinity that is too high comes down only with acid; see how to lower total alkalinity. For the same 30,000-gallon pool, see the amounts of liquid chlorine, shock, salt and stabilizer, or every chemical and size.

Sources (5)

Get an email when the Pool Chemistry Log & Dosing Chart Pack goes on sale

Leave your email and we'll send one message when the Pool Chemistry Log & Dosing Chart Pack is on sale, and occasional updates about it.