How Much Salt for a 10,000-Gallon Pool?
Updated
On this page
Taking a fresh 10,000-gallon pool from no salt to Hayward's 3,200 ppm target takes 267.1 lb of pool salt, or 7 bags of 40 lb. Other generators aim at other levels, so the total runs from 250.4 lb for Jandy AquaPure's 3,000 ppm to 300.4 lb for Pentair IntelliChlor's 3,600 ppm. Most of the time you're topping up a pool that already has salt in it, which the second table covers.
Salt for a new fill, by generator
| Generator | Manual's target | Salt from 0 ppm | 40-lb bags | Level with every bag in |
|---|---|---|---|---|
| Hayward AquaRite | 3,200 ppm | 267.1 lb | 7 | 3,355 ppm |
| Pentair IntelliChlor | 3,600 ppm | 300.4 lb | 8 | 3,834 ppm |
| Jandy AquaPure | 3,000 ppm | 250.4 lb | 7 | 3,355 ppm |
| CircuPool CORE | 3,500 ppm | 292.1 lb | 8 | 3,834 ppm |
Each target is the manual's own. Hayward's reads "The ideal salt level is between 2700-3400 ppm (parts per million) with 3200 ppm being optimal." The pounds come from pounds = gallons × 8.3454 × ppm ÷ 1,000,000, the weight of a gallon of water in pounds from NIST's gallon and pound; the manuals round it to 8.34. Bags are rounded up, which is why the last column runs over the target; where it lands above the manual's own range, hold back part of the last bag.
Topping up a 10,000-gallon pool
| Raise salt by | Salt to add | 40-lb bags, rounded up |
|---|---|---|
| 200 ppm | 16.7 lb | 1 |
| 400 ppm | 33.4 lb | 1 |
| 600 ppm | 50.1 lb | 2 |
| 800 ppm | 66.8 lb | 2 |
| 1,000 ppm | 83.5 lb | 3 |
A whole bag is about 479 ppm in this pool. When you're within one bag of the top of your manual's range, add part of the bag, test the next day, and keep the rest dry for later.
Worked example
A 10,000-gallon pool with a Pentair IntelliChlor reads 3,100 ppm in June after spring rain and a few backwashes. Pentair's ideal is 3,600 ppm. Raising it 500 ppm to 3,600 ppm takes 41.7 lb, which is 2 bags of 40 lb; with every bag in, the pool would read about 4,059 ppm. Pentair's unit turns off below 2,600 ppm, so a pool that keeps losing salt is worth testing monthly.
How the manuals say to add it
Use plain salt. Hayward says "It is important to use only sodium chloride (NaCl) salt that is greater than 99% pure." Jandy's steps are to broadcast it around the edge or the shallow end, and "To avoid clogging the filter or damaging power center and pump, do not add salt through either the skimmer, main drain, or surge tank." CircuPool adds: "Do not throw the salt bag into the water as chemicals and inks on the bag can interfere with water balance." Brush it around until it dissolves, run the pump, and wait before trusting the generator's reading: "The salt display may take 24 hours to respond to the change in salt concentration."
When low salt shuts the generator off
Some units stop making chlorine when salt runs low. Pentair's manual says "Low salt concentration below 2600 ppm will cause the unit to turn off", and Jandy's turns its cell off below 2.0 grams per litre, which is 2,000 ppm. In a 10,000-gallon pool, climbing back from 2,600 to Pentair's 3,600 ppm takes 83.5 lb. The salt cell troubleshooter covers the warning lights once the salt is right.
Is your pool really 10,000 gallons?
Every amount on this page scales with the water, so a pool 20% bigger than you think needs 20% more of everything. Here are two pools that hold close to 10,000 gallons, worked with the same formulas as the pool volume calculator:
| Pool | Gallons |
|---|---|
| A round above-ground pool 21 ft across, 4 ft average depth | 10,364 |
| A rectangle 12 × 24 ft, 4.5 ft average depth | 9,695 |
If yours is another shape, or you only know its size roughly, measure it and run the calculator first. Salt is the one chemical you can't easily take back out, so the volume is worth getting right before the first bag.
The same salt in other pool sizes
| Pool size | 0 to 3,200 ppm | 40-lb bags | +400 ppm |
|---|---|---|---|
| 5,000 gal | 133.5 lb | 4 | 16.7 lb |
| 10,000 gal (this page) | 267.1 lb | 7 | 33.4 lb |
| 15,000 gal | 400.6 lb | 11 | 50.1 lb |
| 20,000 gal | 534.1 lb | 14 | 66.8 lb |
| 25,000 gal | 667.6 lb | 17 | 83.5 lb |
| 30,000 gal | 801.2 lb | 21 | 100.1 lb |
Too much salt can only come down by draining and refilling. For the same 10,000-gallon pool, see the amounts of liquid chlorine, shock, baking soda and stabilizer, or every chemical and size.
Sources (5)
- Hayward, AquaRite 900 manual hayward.com
- Pentair, IntelliChlor IC15–IC60 installation and user's guide pentair.com
- Jandy, AquaPure PureLink manual (H0325600) jandy.com
- CircuPool, CORE series manual circupool.com
- NIST SP 811, Appendix B.8: Factors for units listed alphabetically nist.gov
Get an email when the Pool Chemistry Log & Dosing Chart Pack goes on sale
Leave your email and we'll send one message when the Pool Chemistry Log & Dosing Chart Pack is on sale, and occasional updates about it.