How Much Stabilizer for a 10,000-Gallon Pool?
Updated
On this page
Cyanuric acid stabilizer raises CYA by 10 ppm in a 10,000-gallon pool with 13.4 oz. Taking a fresh fill from 0 to 30 ppm, the bottom of PHTA's ideal range, takes 40.1 oz (2.50 lb), and to 50 ppm, its top, 66.8 oz (4.17 lb). Stabilizer only comes out with water, so it is worth adding in steps rather than overshooting.
Stabilizer doses for a 10,000-gallon pool
| Raise CYA by | Stabilizer (cyanuric acid) |
|---|---|
| 10 ppm | 13.4 oz |
| 20 ppm | 26.7 oz (1.67 lb) |
| 30 ppm | 40.1 oz (2.50 lb) |
| 40 ppm | 53.4 oz (3.34 lb) |
| 50 ppm | 66.8 oz (4.17 lb) |
The amounts are for 100% cyanuric acid, the strength on HASA's Pool Conditioner safety data sheet. PHTA's bulletin notes that most granular products are about 100% active, so a bag labelled stabilizer or conditioner usually needs no correction. Liquid or slurry stabilizers are weaker by weight; follow their own label.
How much CYA to aim for
PHTA's cyanuric acid bulletin puts the ideal at 30 to 50 ppm and adds: "The concentration should not exceed 100 ppm." The MAHC 2024, a public-pool code, is stricter: "The CYA concentration at all AQUATIC VENUES shall remain at or below 90 ppm (mg/L)." Stabilizer protects chlorine from sunlight but slows it down, which is why CDC's minimum free chlorine rises from 1 ppm to 2 ppm once there is any in the water.
Tablets and dichlor add stabilizer as they go. Each 1 ppm of free chlorine from trichlor adds about 0.61 ppm of CYA, so 6.1 ppm for every 10 ppm of chlorine, and dichlor adds about 0.91 ppm. A pool on tablets often needs no stabilizer at all after its first season; what cyanuric acid does covers why.
Worked example
A 10,000-gallon salt pool reads 30 ppm stabilizer in spring. The owner raises it to 50 ppm, the top of PHTA's ideal, since a salt cell makes chlorine steadily and sunlight burns it off. That is a 20 ppm rise, which in 10,000 gallons takes 26.7 oz (1.67 lb). Stabilizer doesn't get used up, so this should last until water is drained or backwashed away.
Adding it
Sources differ on where it goes. PHTA allows the skimmer with care: "Since the granular form is slow to dissolve, if it is fed into the skimmer, care must be taken … to feed the product slowly to avoid blocking the lines." Indiana's health department says "Do not add chemicals to vacuum filter tanks, skimmers or gutters." and "Dissolve powders or crystals in water before adding to the pool." The cautious route follows Indiana: dissolve it in a bucket of water first, pour it in with the pump running, and skip backwashing for a few days so undissolved granules aren't sent to waste.
If you overshoot
No product takes stabilizer out of the water. PHTA lists "Partially drain and refill the pool" first among the ways to reduce it. The share to replace is 1 − target ÷ current, if the fill water has none:
| From | Down to 50 ppm | Water to replace |
|---|---|---|
| 70 ppm | 29% | 2,857 gal |
| 90 ppm | 44% | 4,444 gal |
| 120 ppm | 58% | 5,833 gal |
Is your pool really 10,000 gallons?
Every amount on this page scales with the water, so a pool 20% bigger than you think needs 20% more of everything. Here are two pools that hold close to 10,000 gallons, worked with the same formulas as the pool volume calculator:
| Pool | Gallons |
|---|---|
| A round above-ground pool 21 ft across, 4 ft average depth | 10,364 |
| A rectangle 12 × 24 ft, 4.5 ft average depth | 9,695 |
If yours is another shape, or you only know its size roughly, measure it and run the calculator first. The drain table above depends on it as much as the doses do.
The same doses in other pool sizes
| Pool size | +10 ppm | 0 to 30 ppm | 0 to 50 ppm |
|---|---|---|---|
| 5,000 gal | 6.7 oz | 20.0 oz (1.25 lb) | 33.4 oz (2.09 lb) |
| 10,000 gal (this page) | 13.4 oz | 40.1 oz (2.50 lb) | 66.8 oz (4.17 lb) |
| 15,000 gal | 20.0 oz (1.25 lb) | 60.1 oz (3.76 lb) | 100.1 oz (6.26 lb) |
| 20,000 gal | 26.7 oz (1.67 lb) | 80.1 oz (5.01 lb) | 133.5 oz (8.35 lb) |
| 25,000 gal | 33.4 oz (2.09 lb) | 100.1 oz (6.26 lb) | 166.9 oz (10.43 lb) |
| 30,000 gal | 40.1 oz (2.50 lb) | 120.2 oz (7.51 lb) | 200.3 oz (12.52 lb) |
For the same 10,000-gallon pool, see the amounts of liquid chlorine, shock, salt and baking soda, or every chemical and size.
Sources (4)
Get an email when the Pool Chemistry Log & Dosing Chart Pack goes on sale
Leave your email and we'll send one message when the Pool Chemistry Log & Dosing Chart Pack is on sale, and occasional updates about it.